CRJ 700-900 X - Update 1.2.3.0 Rev 367
Das FSX, FSX:Steam, P3D V4 Add-on "CRJ 700/900 X" wurde auf die Version 1.2.3.0 Rev 367 aktualisiert. Folgende Änderungen wurden vorgenommen:
Für die 64-Bit-Version dieses Updates ist Lockheed Martin Prepar3D v4.3 oder höher erforderlich! Um Support zu erhalten, besuchen Sie unser Forum: http://www.forum.aerosoft.com/
Version 1.2.3.0 / Rev 367:
- [Fixed] Pushbutton clickspots in P3D v4 VC models
- [Fixed] Differential Pressure going off limits when lower altitude is selected
- [Changed] Some changes with Nearest Lists (airports, VORs, NDBs, etc.) updating to avoid CTD on range change
- [Fixed] VNAV issue which cause "above" constraints to be handled as "at" constraints in descent phase
- [Fixed] MFD ADV page ignored L/R setting and only allowed paging for on-side MFD
- [Fixed] No more Nav-to-Nav transfer if a non-LOC approach is selected
- [Fixed] Enabled STAR and transition selection
- [Added] Arrivals page now allows to select runways without an approach procedure (VFR)
- [Fixed] High cabin altitude fluctuation at low flight altitudes
- [Fixed] A condition where a waypoint entered on FPLN page 1 would disappear
- [Fixed] A lonely "DIRECT" indication on FPLN page 1
- [Fixed] The "Cabin Secure" callout is now triggered by closing the main door
- [Fixed] Armed vertical mode is now disarmed when ALT is pressed (GS remains armed)
- [Fixed] Entering waypoint as first waypoint of the flightplan on FPLN page 1 is now possible
- [Fixed] Total distance calculation (FPLN page 1) is now available all the time after departure and arrival have been entered
- [Added] Active airway is shown on FPLN page 2 and following
- [Fixed] Warning/Caution now comes up when engine is starting with any door open
- [Fixed] FCP ALT light doesn't go off anymore when selected altitude is changed
- [Fixed] Dubrovnik (LDDU) Rwy 12 MOKU4C SID turn second (INTC) now turns into the right direction
- [Fixed] Moved HGS radio altitude indicator further down to not block FPV symbol anymore
- [Fixed] TOC calculation for climb with combination of BELOW and ABOVE constraints (LGAV 03R/VARI1J)
- [Fixed] Improved change from (INTC) to DME Arc/Radius to fix legs (LGSM RW27/URNI1C)
- [Fixed] Improved switching to next waypoint at end of DME Arc
Version 1.2.2.3 / Rev 359:
- [Fixed] DAVE screen going black after first menu selection.... second attempt ;)
- [Fixed] Other screens going black after InvalidParameter state of Graphics object
Version 1.2.2.2 / Rev 358:
- [Fixed] DAVE screen going black after first menu selection
- [Fixed] Holding leg distance calculation when time (seconds) is used as distance parameter in navdata
- [Fixed] KSFO 28L OFFSH1 SID display on ND
- [Fixed] PFD attitude indicator vertical alignment
- [Fixed] N1 dropping below idle if power is advanced very carefully
- [Fixed] VNAV calculation now uses CRZ ALT if as maximum altitude if no previous altitude constraint is found
- [Fixed] Function to find previous altitude constraint now skips departure waypoints
- [Fixed] VNAV profile and ToD calculation (special cases with (VECT), discos and constraints)
- [Fixed] Tracking for Heading to DME Distance legs
- [Fixed] A rare condition that could cause auto pressurization system go to descent mode while on cruise altitude
- [Fixed] HUD speed trend indicator stuck
- [Fixed] NAV-to-NAV transfer doesn't block manual frequency tuning any longer
- [Fixed] FMS now loads terminal procedure legs even when RNP field is missing (RNP defaults to 1.0 NM in this case)
- [Added] Force FSX/P3D fuel pumps to OFF after loading to avoid FSX/P3D fuel pump sound
- [Added] Ground roll sound and bump on nose gear touchdown
- [Added] HGS Flare command for AIII mode
- [Added] HGS Flare cue for other modes
- [Fixed] MFD ADV page text/map mode switching
- [Fixed] VNAV profile calculation with manually entered waypoints ("step descent")
- [Fixed] Altitude alert is no longer triggered by FCP alt selection knob
- [Fixed] Removed turnover from NAV SOURCE selector (now moves only moves FMS1, VOR/NAV1, OFF, VOR/NAV2, FMS2)
- [Fixed] Active transponder code shown in green on MCDU Radio page
- [Fixed] "Gear Bay Overheat" sound plays completely even if button is released early
- [Fixed] After forced autopilot disconnect (yoke movement), chime sound loops until AP is properly disconnected
Passende Artikel