CRJ 700/900 X - Update V1.0.5.0

Das FSX/FSX:SE/P3D Add-on "CRJ 700/900 X" wurde auf die Version 1.0.5.0 (REV 324) aktualisiert. Folgende Änderungen wurden vorgenommen:

Hinweis: Die 64-bit Version von diesem Update benötigt Lockheed Martin Prepar3D v4.2 oder höher!

  • [Fixed] HGS artifacts on windscreen removed
  • [Fixed] Dave now controls the right doors in FSX
  • [Fixed] Zoom corrected in FSX/P3Dv3 preview window
  • [Fixed] Frequencies and transponder codes on RADIO page can now be transferred to scratchpad
  • [Fixed] Pressurization mode switching during descent
  • [Added] Cabin climb/descent with packs switched off
  • [Fixed] Several pushbuttons have been fixed to work with the left mouse button as well
  • [Fixed] External APU sound not looping properly
  • [Fixed] Crackling sound issue with APU on
  • [Fixed] Door positions corrected (special thanks to Eduard and Richcam for their input!) for better jetway docking
  • [Fixed] Time and fuel calculations sometimes gave invalid results on the ground with an incomplete flightplan
  • [Fixed] Wrong turns on (VECT) legs
  • [Fixed] Removed distance and time-to-go indications for (VECT) legs on MFD
  • [Fixed] Changed minimum airport distance and configuration conditions for FA landing announcements
  • [Fixed] Reverser spool-up works again
  • [Fixed] PFD "SYNC" message now properly disappears a few seconds after synchronizing flight director
  • [Fixed] Departure runway selection disappearing after SID selection (if SID's runway is set to "ALL")
  • [Fixed] ILS frequency on ARR DATA page can now be copied to scratchpad for use on RADIO page
  • [Fixed] Decreased overshoot on track capture (introduced with rev 311)
  • [Fixed] Sign error on wind correction during initial waypoint turn
  • [Fixed] Only first letter of current and next waypoint shown on PROG page
  • [Fixed] Ice detection after changing payload in DAVE now only when engines are running
  • [Fixed] Single cue FD now points into the right direction
  • [Fixed] Range-to-altitude ring now uses vertical speed trend instead of current vertical speed for more consistent indication
  • [Fixed] Increased cabin rate change for altitudes above 20000ft
  • [Fixed] Selection of Runway-SID-Transition as SID
  • [Fixed] Increased the size of text buffers for PROG page
  • [Changed] Changed "(P-TURN)" into "(P-T)" for PROG page
  • [Fixed] HUD FPV and FD cue visibility
  • [Fixed] Bleed Air source now switched to BOTH after takeoff when both throttles are pulled out of the TOGA detent
  • [Fixed] Corrected begin of turn point for turns with more than 60 degrees (official FAA formula results in early turn)
  • [Fixed] PFD/MFD CDI inverted with FMS as nav source
  • [Fixed] CDI calculation (= cross track error) would result in off-track indication even though the aircraft is "on the line"
  • [Fixed] Rounding error on MFD Data page ETE calculation
  • [Fixed] CTD when selecting an arrival runway for the second time while flightplan is still empty
  • [Fixed] SID data is now loaded when the selected departure procedure is a Runway-SID transition instead of a SID (U.S. style SIDs)
  • [Fixed] Improved holding tracking
  • [Fixed] Saving a flightplan no longer tries to save holdings
  • [Fixed] Editing holdings now switches to MOD FPLN and requires EXEC to become active
  • [Fixed] Bleed air auto mode logic (Thanks to Ak47e6 for the excellent description!)
  • [Fixed] CTD when entering user-defined waypoint (certain circumstances only)
  • [Fixed] Maximum wind speed on PERF INIT page increased from 99 to 999 knots
  • [Fixed] Stopped VNAV calculation cycle from overwriting manually entered winds on LEGS WIND pages
  • [Fixed] Vertical eyepoint position corrected for HGS alignment (-700 and -900)
  • [Fixed] HGS glideslope symbol is no longer cut off on right side
  • [Fixed] Removed HGS clickspot from the windscreen
  • [Fixed] Clocks now show the proper format for CHR (":MM") and ET ("HH:MM")
  • [Fixed] Thrust reversers now close when throttle is advanced while reversers are open
  • [Fixed] APU START/STOP button animation and clickspot logic
  • [Fixed] DIR/INTC page waypoint selection logic
  • [Fixed] DIR/INTC on-fpln waypoint directs
  • [Added] Automatic pressurization implemented
  • [Added] EMER DEPRESS EICAS message
  • [Fixed] Waypoint sequencing logic
  • [Fixed] Waypoint turn calculation
  • [Fixed] Service door now works again (also animation stuttering fixed)
  • [Fixed] Power settings in detents now fit the calculated settings again
  • [Fixed] Doors control in FSX
  • [Changed] CRJ Manager: seat editor changed to "passenger" or "no passenger" selection (instead of male, female, child)
  • [Added] CRJ Manager: Automatic synchronization between CRJ Manager and DAVE
  • [Fixed] CRJ Manager: Missing payload update for FSX
  • [Fixed] CRJ Manager: CoG and trim calculation
  • [Fixed] DAVE: CoG and trim calculation
  • [Fixed] Cabin announcements no longer audible when deselected in CRJ Manager
  • [Fixed] Flight attendant talking on flightdeck no longer audible when deselected in CRJ Manager
  • [Fixed] Reverser animation length adjusted
  • [Fixed] Bug in abeam check function that would cause early waypoint sequencing

Tags: Update
Passende Artikel
CRJ 700/900 X CRJ 700/900 X
  42,01 € *
News
Maastricht-Aachen (P3D V4) - Update V1.0.1.0

Das Prepar3D V4 Add-on Maastricht-Aachen wurde auf die Version 1.0.1.0 aktualisiert. Folgende... [mehr]

Köln/Bonn professional - Update 1.0.5.0

Das Prepar3D V4.3+ Add-on Köln/Bonn professional wurde auf die Version 1.0.5.0 aktualisiert.... [mehr]

WORK IN PROGRESS: Bus Mechanic Simulator

Aerosoft freut sich, den Bus Mechanic Simulator anzukündigen: Zusammen mit VIS Games und dem von... [mehr]

Neoplan Skyliner & ComfortClass HD für den...

Die Tourist Bus Simulator Add-ons Neoplan Skyliner & ComfortClass sind ab sofort als Download im... [mehr]

WORK IN PROGRESS: OMSI 2 Add-on Köln

Auf den WORK IN PROGRESS Screenshots bekommen Sie einen ersten Eindruck von "OMSI 2 Add-on Köln",... [mehr]

Erstes DevDiary von Rescue HQ - The Tycoon

Wie baut man sein erstes Headquarter? Genau diese Frage beantwortet Ihnen Chris von stillalive... [mehr]

Airport Frankfurt XP - Update 1.10

Das XPlane 11 Add-on Airport Frankfurt XP wurde auf die Version 1.10 aktualisiert. Folgende... [mehr]

Jetzt erhältlich: OMSI 2 Add-on Urbino...

Das OMSI 2 Add-on Urbino Stadtbusfamilie ist ab sofort als Download im Aerosoft Online Shop... [mehr]

Jetzt erhältlich: Airport Bergamo XP

Das XPlane 11 Add-on "Airport Bergamo XP" ist ab sofort als Download im Aerosoft Online Shop... [mehr]

Jetzt erhältlich: TS Add-on...

Das beliebte Train Simulator Add-on Münster-Bremen ist ab sofort als Box erhältlich! [mehr]