CRJ 700-900 X - Update 1.2.3.0 Rev 367

The FSX, FSX:Steam, P3D V4 add-on "CRJ 700/900 X" has been updated to version 1.2.3.0 Rev 367. Following changes have been made:

The 64-bit version of this update requires Lockheed Martin Prepar3D v4.3 or higher! For all support, come to our forum: http://www.forum.aerosoft.com/

Version 1.2.3.0 / Rev 367:

  • [Fixed] Pushbutton clickspots in P3D v4 VC models
  • [Fixed] Differential Pressure going off limits when lower altitude is selected
  • [Changed] Some changes with Nearest Lists (airports, VORs, NDBs, etc.) updating to avoid CTD on range change
  • [Fixed] VNAV issue which cause "above" constraints to be handled as "at" constraints in descent phase
  • [Fixed] MFD ADV page ignored L/R setting and only allowed paging for on-side MFD
  • [Fixed] No more Nav-to-Nav transfer if a non-LOC approach is selected
  • [Fixed] Enabled STAR and transition selection
  • [Added] Arrivals page now allows to select runways without an approach procedure (VFR)
  • [Fixed] High cabin altitude fluctuation at low flight altitudes
  • [Fixed] A condition where a waypoint entered on FPLN page 1 would disappear
  • [Fixed] A lonely "DIRECT" indication on FPLN page 1
  • [Fixed] The "Cabin Secure" callout is now triggered by closing the main door
  • [Fixed] Armed vertical mode is now disarmed when ALT is pressed (GS remains armed)
  • [Fixed] Entering waypoint as first waypoint of the flightplan on FPLN page 1 is now possible
  • [Fixed] Total distance calculation (FPLN page 1) is now available all the time after departure and arrival have been entered
  • [Added] Active airway is shown on FPLN page 2 and following
  • [Fixed] Warning/Caution now comes up when engine is starting with any door open
  • [Fixed] FCP ALT light doesn't go off anymore when selected altitude is changed
  • [Fixed] Dubrovnik (LDDU) Rwy 12 MOKU4C SID turn second (INTC) now turns into the right direction
  • [Fixed] Moved HGS radio altitude indicator further down to not block FPV symbol anymore
  • [Fixed] TOC calculation for climb with combination of BELOW and ABOVE constraints (LGAV 03R/VARI1J)
  • [Fixed] Improved change from (INTC) to DME Arc/Radius to fix legs (LGSM RW27/URNI1C)
  • [Fixed] Improved switching to next waypoint at end of DME Arc

 

Version 1.2.2.3 / Rev 359:

  • [Fixed] DAVE screen going black after first menu selection.... second attempt ;)
  • [Fixed] Other screens going black after InvalidParameter state of Graphics object

 

Version 1.2.2.2 / Rev 358:

  • [Fixed] DAVE screen going black after first menu selection
  • [Fixed] Holding leg distance calculation when time (seconds) is used as distance parameter in navdata
  • [Fixed] KSFO 28L OFFSH1 SID display on ND
  • [Fixed] PFD attitude indicator vertical alignment
  • [Fixed] N1 dropping below idle if power is advanced very carefully
  • [Fixed] VNAV calculation now uses CRZ ALT if as maximum altitude if no previous altitude constraint is found
  • [Fixed] Function to find previous altitude constraint now skips departure waypoints
  • [Fixed] VNAV profile and ToD calculation (special cases with (VECT), discos and constraints)
  • [Fixed] Tracking for Heading to DME Distance legs
  • [Fixed] A rare condition that could cause auto pressurization system go to descent mode while on cruise altitude
  • [Fixed] HUD speed trend indicator stuck
  • [Fixed] NAV-to-NAV transfer doesn't block manual frequency tuning any longer
  • [Fixed] FMS now loads terminal procedure legs even when RNP field is missing (RNP defaults to 1.0 NM in this case)
  • [Added] Force FSX/P3D fuel pumps to OFF after loading to avoid FSX/P3D fuel pump sound
  • [Added] Ground roll sound and bump on nose gear touchdown
  • [Added] HGS Flare command for AIII mode
  • [Added] HGS Flare cue for other modes
  • [Fixed] MFD ADV page text/map mode switching
  • [Fixed] VNAV profile calculation with manually entered waypoints ("step descent")
  • [Fixed] Altitude alert is no longer triggered by FCP alt selection knob
  • [Fixed] Removed turnover from NAV SOURCE selector (now moves only moves FMS1, VOR/NAV1, OFF, VOR/NAV2, FMS2)
  • [Fixed] Active transponder code shown in green on MCDU Radio page
  • [Fixed] "Gear Bay Overheat" sound plays completely even if button is released early
  • [Fixed] After forced autopilot disconnect (yoke movement), chime sound loops until AP is properly disconnected

 


Related products
News
Maastricht-Aachen (P3D V4) - Update V1.0.1.0

The Prepar3D V4 add-on Maastricht-Aachen has been updated to version 1.0.1.0. Following changes... [more]

Cologne/Bonn professional - Update 1.0.5.0

The Prepar3D V4.3+ add-on Cologne/Bonn professional has been updated to version 1.0.5.0.... [more]

WORK IN PROGRESS: Bus Mechanic Simulator

Aerosoft is happy to announce Bus Mechanic Simulator: Together with VIS Games and the well-known... [more]

Neoplan Skyliner & ComfortClass HD for the...

The Tourist Bus Simulator add-ons Neoplan Skyliner & ComfortClass are available as download in... [more]

WORK IN PROGRESS: OMSI 2 Add-on Cologne

On the WORK IN PROGRESS screenshots you get a first impression of "OMSI 2 Add-on Cologne", which... [more]

Airport Frankfurt XP - Update 1.10

The XPlane 11 add-on Airport Frankfurt XP has been updated to version 1.10. Following changes... [more]

Available now: OMSI 2 Add-on Urbino...

The OMSI 2 add-on Urbino Citybus Series is available as download in the Aerosoft Online Shop . [more]

Available now: Airport Bergamo XP

The XPlane 11 add-on "Airport Bergamo XP" is available now as download in the Aerosoft Online Shop. [more]

Available now: TS add-on "Muenster-Bremen"...

The popular Train Simulator add-on Muenster-Bremen is available now as a box! [more]

Aerosoft A318/A319/A320/A321 professional...

The Prepar3D V4.4 add-ons "Aerosoft A318/A319 professional" & "Aerosoft A320/A321 professional"... [more]