CRJ 700/900 X - Update V1.0.5.0

The FSX/FSX:SE/P3D add-on "CRJ 700/900 X" has been updated to version 1.0.5.0 (REV 324). Following changes have been made:

Note: The 64-bit version of this update requires Lockheed Martin Prepar3D v4.2 or higher!

  • [Fixed] HGS artifacts on windscreen removed
  • [Fixed] Dave now controls the right doors in FSX
  • [Fixed] Zoom corrected in FSX/P3Dv3 preview window
  • [Fixed] Frequencies and transponder codes on RADIO page can now be transferred to scratchpad
  • [Fixed] Pressurization mode switching during descent
  • [Added] Cabin climb/descent with packs switched off
  • [Fixed] Several pushbuttons have been fixed to work with the left mouse button as well
  • [Fixed] External APU sound not looping properly
  • [Fixed] Crackling sound issue with APU on
  • [Fixed] Door positions corrected (special thanks to Eduard and Richcam for their input!) for better jetway docking
  • [Fixed] Time and fuel calculations sometimes gave invalid results on the ground with an incomplete flightplan
  • [Fixed] Wrong turns on (VECT) legs
  • [Fixed] Removed distance and time-to-go indications for (VECT) legs on MFD
  • [Fixed] Changed minimum airport distance and configuration conditions for FA landing announcements
  • [Fixed] Reverser spool-up works again
  • [Fixed] PFD "SYNC" message now properly disappears a few seconds after synchronizing flight director
  • [Fixed] Departure runway selection disappearing after SID selection (if SID's runway is set to "ALL")
  • [Fixed] ILS frequency on ARR DATA page can now be copied to scratchpad for use on RADIO page
  • [Fixed] Decreased overshoot on track capture (introduced with rev 311)
  • [Fixed] Sign error on wind correction during initial waypoint turn
  • [Fixed] Only first letter of current and next waypoint shown on PROG page
  • [Fixed] Ice detection after changing payload in DAVE now only when engines are running
  • [Fixed] Single cue FD now points into the right direction
  • [Fixed] Range-to-altitude ring now uses vertical speed trend instead of current vertical speed for more consistent indication
  • [Fixed] Increased cabin rate change for altitudes above 20000ft
  • [Fixed] Selection of Runway-SID-Transition as SID
  • [Fixed] Increased the size of text buffers for PROG page
  • [Changed] Changed "(P-TURN)" into "(P-T)" for PROG page
  • [Fixed] HUD FPV and FD cue visibility
  • [Fixed] Bleed Air source now switched to BOTH after takeoff when both throttles are pulled out of the TOGA detent
  • [Fixed] Corrected begin of turn point for turns with more than 60 degrees (official FAA formula results in early turn)
  • [Fixed] PFD/MFD CDI inverted with FMS as nav source
  • [Fixed] CDI calculation (= cross track error) would result in off-track indication even though the aircraft is "on the line"
  • [Fixed] Rounding error on MFD Data page ETE calculation
  • [Fixed] CTD when selecting an arrival runway for the second time while flightplan is still empty
  • [Fixed] SID data is now loaded when the selected departure procedure is a Runway-SID transition instead of a SID (U.S. style SIDs)
  • [Fixed] Improved holding tracking
  • [Fixed] Saving a flightplan no longer tries to save holdings
  • [Fixed] Editing holdings now switches to MOD FPLN and requires EXEC to become active
  • [Fixed] Bleed air auto mode logic (Thanks to Ak47e6 for the excellent description!)
  • [Fixed] CTD when entering user-defined waypoint (certain circumstances only)
  • [Fixed] Maximum wind speed on PERF INIT page increased from 99 to 999 knots
  • [Fixed] Stopped VNAV calculation cycle from overwriting manually entered winds on LEGS WIND pages
  • [Fixed] Vertical eyepoint position corrected for HGS alignment (-700 and -900)
  • [Fixed] HGS glideslope symbol is no longer cut off on right side
  • [Fixed] Removed HGS clickspot from the windscreen
  • [Fixed] Clocks now show the proper format for CHR (":MM") and ET ("HH:MM")
  • [Fixed] Thrust reversers now close when throttle is advanced while reversers are open
  • [Fixed] APU START/STOP button animation and clickspot logic
  • [Fixed] DIR/INTC page waypoint selection logic
  • [Fixed] DIR/INTC on-fpln waypoint directs
  • [Added] Automatic pressurization implemented
  • [Added] EMER DEPRESS EICAS message
  • [Fixed] Waypoint sequencing logic
  • [Fixed] Waypoint turn calculation
  • [Fixed] Service door now works again (also animation stuttering fixed)
  • [Fixed] Power settings in detents now fit the calculated settings again
  • [Fixed] Doors control in FSX
  • [Changed] CRJ Manager: seat editor changed to "passenger" or "no passenger" selection (instead of male, female, child)
  • [Added] CRJ Manager: Automatic synchronization between CRJ Manager and DAVE
  • [Fixed] CRJ Manager: Missing payload update for FSX
  • [Fixed] CRJ Manager: CoG and trim calculation
  • [Fixed] DAVE: CoG and trim calculation
  • [Fixed] Cabin announcements no longer audible when deselected in CRJ Manager
  • [Fixed] Flight attendant talking on flightdeck no longer audible when deselected in CRJ Manager
  • [Fixed] Reverser animation length adjusted
  • [Fixed] Bug in abeam check function that would cause early waypoint sequencing

Tags: Update
Related products
CRJ 700/900 X CRJ 700/900 X
  $49.99 *
News
Available now: Tourist Bus Simulator

The new Tourist Bus Simulator of the developer TML Studios is available now as download and box... [more]

Mega Airport Madrid professional - Update...

The Prepar3D V4 add-on "Mega Airport Madrid professional" has been updated to version 1.1.0.0.... [more]

Available now: Muenster-Bremen | Train...

The new Train Simulator 2019 add-on Muenster-Bremen of the developer virtualTracks.net is... [more]

Available now: Airport Genoa XP

Head for the most important Ligurian airport in Italy’s north-west and its unique approach with... [more]

Köln/Bonn professional available now as box!

If you like to hold something in your hand: the Köln/Bonn professional box is available now! [more]

WORK IN PROGRESS: Sim-wings Canary Islands...

On the WORK IN PROGRESS screenshots you get a first impression of "Sim-wings Canary Islands... [more]

Top Deals of the week!

Do not miss our Top Deals of the week exclusively for you at the Aerosoft Online Shop! [more]

WORK IN PROGRESS: Faroe Islands XP

On the WORK IN PROGRESS screenshots you get a first impression of "Faroe Islands XP". [more]

WORK IN PROGRESS: Lukla - Mount Everest

New WORK IN PROGRESS Screenshots of Lukla - Mount Everest can be found in this forum thread -... [more]

Prepar3D V4.4 available!

The fourth update for Lockheed Prepard3D V4 has been released! Version 4.4 includes many... [more]